Professional Documents
Culture Documents
Esas Quiz
Esas Quiz
2.Determine the outside diameter of a hollow steel tube that will carry a tensile load of 500 kN at a stress of 140 MN/m². Assume the
wall thickness to be one tenth of the outside diameter. *
3.A solid cylinder rolls from rest down an inclined plane 1.2 m high without slipping. What is its linear velocity at the foot of the
plane? *
3.96 m/s 4.82 m/s
5.42 m/s 2.68 m/s
4.What refers to the cumulative effect of elapsed time on the money value of an event, based on the earning power of equivalent
invested funds capital should or will earn? *
5.Which of the following situations has a conventional cash flow so that an internal rate of return can be safely calculated and
used? *
Your company undertakes a mining project in which the land must be reclaimed at the end of the project.
You lease a car and pay by the month.
You purchase a house and pay the bank in monthly installments.
You invest in a safe dividend stock and receive dividends each year.
Other:
6.Two 100-mm diameter are connected by means of two flanges with 20-mm diameter bolts equally spaced on a circle of 20 cm
diameter. If the maximum shear in the shaft due to torque is not to exceed 80 Mpa and average shear strength of the bolts is not to
be exceed 60 MPa for the same torque, determine the number of bolts required. *
9 10
8 7
7.A force of 120 N has a rectangular component of 84 N acting along a line making an angle of 20 degrees counterclockwise from
the positive x axis. What angle does the 120-N force make with the positive x axis? *
244 mm 234 mm
134 mm 144 mm
9.Mr. Johnson borrows $100,000 at 10% effective annual interest. He must pay back the loan over 30 years with uniform monthly
payments due on the first day of each month. What does Mr. Johnson pay each month? *
$878 $870
$846 $839
10.Every object continues in its state of rest, or of uniform velocity in a straight line, as long as no net force acts on it. This statement
is in accordance to *
Newton's Third Law of Motion Newton's Second Law of Motion Newton's First Law of Motion
11.A steel beam 2 m in length is simply supported at each and carries a concentrated load of 100 kN acting 0.5 m from one of the
supports. Determine the maximum bending stresses set up in the beam if the cross section is rectangular, 100 mm wide by 150 mm
deep. *
12.When a body is subjected to three mutually perpendicular stresses, of equal intensity, the ratio of direct stress to the
corresponding volumetric strain is known as *
13.Is a measure of the effectiveness of an investment of a capital. *
15.A manufacturer desires to set aside a certain sum of money to provide funds to cover the yearly operating expenses and the cost
of replacing every year the dies of stamping machine used in making radio chassis as model changes for a period of 10 years.
Operating Cost per year = P500; Cost of Die = P1,200; Salvage Value = P600; The money will be deposited in a savings account
earning 6% interest. Determine the sum of money that must be deposited, including the cost of initial die. *
P9,796.10 P9,296.10
P8,296.10 P8,096.10
16.A mass of 200 kg is held by passing a rope around a horizontal post and exerting a pull of 220 N. If the coefficient of friction
between the post and the rope is 1/4, how many turns of the rope around the post are necessary? *
1.93 turns
1.82 turns
1.28 turns
1.39 turns
18.In any collision, which of the following is conserved: *
19.What gives the average ratio of stress to strain for materials operating in the non-linear region in the stress-strain diagram? *
20.The cost of equipment is P500,000 and the cost of installation is P30,000. If the salvage value is 10 percent of the cost of
equipment at the end of 5 years, determine the book value at the end of the fourth year. Use straight-line method. *
P146,000.00
P147,950.90
P146,320.50
P147,000.00
ESAS QUIZ 2
MgCO₃ MgCO₂
Mg₂CO₃ Mg₃CO₂
2.Thirty kilojoules of heat is removed from 1.4 kg of ice initially at −10 deg C. Its new temperature is *
3.A certain quantity of a gas has a volume of 1200 cu. cm. at 27 deg C. What it is volume at 127 deg C if its pressure remains
constant? *
4.The density at 20 deg C of a sulfuric acid solution containing 65.0% by weight of H₂SO₄ is 1.55 g/cc. What is the molarity of the
solution? *
5.5 M 24.3 M
15.8 M 10.3 M
anode proton
electron ion
6.The pOH of the water in a fish tank is found to be 6.59. What is the [ OH-] for this water? *
7.An iceberg in the ocean floats with one seventh of its volume above the surface. Unit weight of ocean water is 64 pcf. What is the
specific gravity relative to ocean water? *
0.798 0.786
0.857 0.879
8.Which of the following metals does not resist corrosion? *
Fe Cu
Ni Pb
6.35 m 5.25 m
51.47 m 0.632 m
11.What is the volume at standard temperature and pressure of 16 grams of gaseous sulfur dioxide, SO₂? *
12.Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves the same stage with an enthalpy of 2846 kJ/kg
and a velocity of 124 m/s. Calculate the work done by the steam. *
998.7 kJ/kg 766.8 kJ/kg
988.7 kJ/kg 776.8 kJ/kg
Adhesion Cohesion
Viscosity Compressibility
14.In Joule cycle, heat is rejected at constant *
Pressure Entropy
Temperature Volume
15.What is the force due to the liquid only acting on a circular plate 2 in in diameter which covers a hole in the bottom of a tank of oil
4 ft high, if the specific gravity is 0.5? *
1.26 lb 2.71 lb
2.17 lb 1.62 lb
16.An adiabatic process with no work done is: *
isometric isobaric
throttling polytropic
17.An atom of beryllium consists of 4 protons, 5 neutrons, and 4 electrons. The mass number of this atom is *
13 8
9 5
18.A reference frame which remains fixed, while fluid flows through it is called: *
Stokesian Bernoullian
Eulerian Lagrangian
19.It state that if two bodies are in thermal equilibrium with a third body, they are also in thermal equilibrium with each other. *
20.Operation of McLeod gauge used for low pressure measurement is based on the principle of *
byte band
nibble data bus
2.How many atoms are there per unit cell for a face-centered cubic structure? *
1 3
4 2
3.Medium voltage cable insulations is rated for _______volts or higher. *
600 2001
230 1000
4.A fish frozen in the clear ice (n = 1.3) of a frozen lake appears to be 40 cm below the surface. Its actual depth is *
80 cm 52 cm
31 cm 46 cm
5.The Implementing Rules and Regulations (IRR) of RA 7920 was approved under Board Resolution No.____ series of 1995. *
18 16
22 24
6.Extreme toxic label for pesticide is denoted by __________. *
yellow blue
green red
9.An automobile moving at 30.0 m/s is approaching a factory whistle that has a frequency of 500 Hz. If the speed of sound in air is
340 m/s, what is the apparent frequency of the whistle as heard by the driver? *
456 Hz 462 Hz
566 Hz 544 Hz
10.Motor A has a full load current of 8 A and motor B, 10 A. What is the ampacity of the feeder conductor supplying these two
motors? *
18 A 24.2 A
20.5 A 9A
11.RA 9136 has four sectors, which of the following is not included? *
distribution supply
system operation generation
12.When an input signal A = 10100 is applied to a NOT gate, its output signal is *
01001 00101
01011 10101
13.Intermediate metal conduit shall be shipped in standard lengths of __________. *
14.Constantan, an alloy used in thermocouples, is an alloy of *
15.Gun Metal is an alloy of *
Frame Path
Group Block
17.It is the property which enables a materials to resist abrasion and indentation. *
Ductility Hardness
Malleability Stiffness
18.Article II of Code of Ethics for Electrical Engineers contains: *
SEC. 1 to 9 SEC. 1 to 8
SEC. 1 to 7 SEC. 1 to 6
19.It is the term used to describe the complete process of bringing a new product or service to market. *
asthenosphere lithosphere
troposphere benthosphere