FR91536 6bta5.9-C180 (Industrial) Datasheet en
FR91536 6bta5.9-C180 (Industrial) Datasheet en
Techical
Operations
Performance curve
Torque Output
rpm N.m
800 400
800
1000 598
700 1200 738
1300 750
Torque N.m
600
1400 738
500 1500 728
1600 709
400 1800 660
2000 628
300
800 1000 1200 1400 1600 1800 2000 2200 2100 606
Engine Speed rpm
2200 575
Power Output
rpm kW
140
800 34
120 1000 63
1200 93
100
1300 102
Power kW
80 1400 108
60 1500 114
1600 119
40
1800 125
20 2000 131
800 1000 1200 1400 1600 1800 2000 2200
Engine Speed rpm 2100 133
2200 132
Fuel Consumption
250 rpm g/kW.h
800 231
240 1000 221
Fuel Consumption g/kW.h
1200 215
230
1300 212
220 1400 209
1500 207
210 1600 206
1800 210
200
2000 216
800 1000 1200 1400 1600 1800 2000 2200
Engine Speed rpm 2100 221
2200 227
Curves shown above represent gross engine performance capabilities obtained and corrected in accordance with GB/T18297
conditions of 100kPa (29.61 in. Hg) barometric pressure [80 m (263 ft.) altitude], 25°C (77°F) inlet air temperature, and 1 kPa (0.30 in.
Hg) water vapor pressure with No.2 diesel fuel. The engine may be operated without changing the fuel setting up to 2200 m (7,218 ft.)
altitude. For sustained operation at high altitudes, the fuel rate of the engine will be adjusted to limit performance by 4% per 305 m
(1,000 ft.) above 2255 m (7,400 ft.) altitude and 2% per 11°C above 38°C (1% per 10°F above 100°F).
FR91536 (Continued) Page: 2
GENERAL ENGINE DATA
Approximate Engine Weight (wet)…………………………………………………-kg 453
Mass Moment of Inertia of Rotating Components (No Flywheel)………………-kg·m2 0.25
Center of Gravity from Front Face of Block………………………………………-mm 391
Center of Gravity above Crankshaft Centerline…………………………………-mm 140
ENGINE MOUNTING
Maximum (Static) Bending Moment at Front Support Mounting Surface…… -N.m 435
Maximum (Static) Bending Moment at Side Pad Mounting Surface………… -N.m TBD
Maximum (Static) Bending Moment at Rear Face of Block……………………-N.m 1356
Moment of Inertia of Complete Engine
— Roll Axis……………………………………………………………………-kg·m2 16.5
2
— Pitch Axis…………………………………………………………………-kg·m 41.1
— Yaw Axis………………………………………………………………… -kg·m2 35.4
Crankshaft Thrust Bearing Load Limit
—Maximum Intermittent……………………………………………………-N 3425
—Maximum Continuous……………………………………………………-N 1112
EXHAUST SYSTEM
Maximum Back Pressure………………………………………………………… -kPa 10
Exhaust Pipe Size Normally Acceptable…………………………………………-mm 75
Maximum Static Supported Weight at the Turbocharger Outlet Flange………-N.m 13.5
Exhaust Manifold Insulation Acceptable…………………………………………-Yes/No No
Turbocharger Insulation Acceptable………………………………………………-Yes/No No
LUBRICATION SYSTEM
Normal Operating Oil Pressure Range…….…………………………………… -kPa 69 - 345
Maximum Lube Oil Flow for Engine Accessories…….…………………………-litre/min. 4.0
Maximum Sump Oil Temperature……………….…………………………………
-℃ 127
Minimum Engine Oil Pressure for Engine Protection Devices:
— At Rated Speed and Load……………………………………………… -kPa 276
— At Torque Peak Speed and Load……………………………………… -kPa 207
— At Low Idle…………………………………………………………………-kPa 69
Minimum Required Lube System Capacity - Sump plus Filters…….…………-litre 16.3
By-pass Filtration Required………………………………………………….…… -Yes/No No
Angularity of Standard Oil Pan: (Values stated are for intermittent operation only):
— Front Down…………………………………………………………………- º 45
— Front Up……………………………………………………………………- º 45
— Side to Side……………………………………………………………… - º 45
FR91536 (Continued) Page: 3
COOLING SYSTEM
Coolant Capacity - Engine Only…………………………………………………………-litre 10.4
Maximum Engine Cooling Circuit External Resistance……………………………… -kPa 34
Minimum Pump Inlet Pressure with Open Thermostat and no Pressure Cap………-mmHg TBD
Maximum Static Head of Coolant Above Engine Crankshaft Centerline.……………-m TBD
Standard (modulating) Thermostat Range……………………………………………… -℃ 82-93
Maximum Block Coolant Pressure with Closed Thermostat and no Pressure Cap -kPa 276
Minimum Pressure Cap…………………………………………………………………… -kPa 50
Maximum Engine Coolant Temperature at Engine Outlet……………………………-℃ 100
Maximum Engine Coolant Temperature for Engine Protection Devices……………-℃ 101.6
Minimum Engine Coolant Temperature…………………………………………………-℃ 71
Minimum Fill Rate…………………………………………………………………………-litre/min. 19
Maximum Initial Fill Time…………………………………………………………………-min. 5
Minimum Coolant Expansion Space……….…...………….……...………….……...…- % 6
Maximum Deaeration Time………………………………………………………………-min. 25
Minimum Drawdown…………………………………………….…………………….… - % 11
(Drawdown Must Exceed the Volume Not Filled at Initial Fill & Must Not Include Expansion Space)
Fan-on Engine Coolant Outlet Temperature……………………………………………-℃ 93
Shutter Opening Coolant Outlet Temperature…………………………………………-℃ 85
FUEL SYSTEM
Maximum Fuel Flow on the Supply Side of the Fuel Pump………………………… -kg/hr 193
Maximum Fuel Inlet Restriction
— with clean fuel filter………………………………………………………………-kPa 14
— with dirty fuel filter………………………………………………………………-kPa 27
Maximum Fuel Drain Restriction
— with check valves……………………………………………………………… -kPa TBD
— less check valves……………………………………………………………… -kPa 68
Maximum Fuel Inlet Temperature……………………………………………………… -℃ 71
Minimum Fuel Tank Air Venting Capability Required at 6 in. H2O Back Pressure…-litre/hr 340
FR91536 (Continued) Page: 4
EMISSIONS
Estimated Free Field Sound Pressure Level At 15 m (50 ft.) and Full-Load Governed Speed
(Excludes Noise from Intake, Exhaust, Cooling System and Driven Components)
—Right Side………………………………………………………………-dBa TBD
—Left Side……………………………………………………………...…-dBa TBD
—Front……………………………………………………………………-dBa TBD
—Rear…………………………………………………………………… -dBa TBD
Gaseous Emissions per ISO 8178
—Weight-Specific NOx………………………………………………… -g/kW.h 7.69
—Weight-Specific HC……………………………………………………-g/kW.h 0.42
—Weight-Specific CO……………………………………………………-g/kW.h 0.43
—Weight-Specific Particulates…………………………………………-g/kW.h 0.168
Performance Data
Minimum low idle speed:………………………………………………………-rpm 800
Maximum Governed Speed(10% of Rated Torque).……………………-rpm 2450
Maximum altitude limit restriction
—Continous…...………………………………………………… -m 3000
Maximum torque available at closed throttle low idle speed………………-N.m N/A
Nominal governor regulation:…………………………………………………-% ≤8
Throttle Angle
—High Idle…...……………………………………………………………Deg. 103±5°
—Low Idle…………………………………………………………………Deg. 70±5°
—Delta…………………………………………………………………… Deg. 33°
Throttle Angle at Engine Shutdown
—Engine Work…...………………………………………………………Deg. 105±5°
—Engine Shutdown…...…………………………………………………Deg. 46±5°
Maximum
Rated Power Torque Peak
Power
Engine Speed…………………………………………………… -rpm 2200 1300
Output Power…………………………………………………… -kW 132 102
Torque…………………………………..…………………………-N.m 575 750
Intake Manifold Pressure……………………………………… -kPa 115 105
Friction Horsepower……………………………………………… -kW 15 9
Inlet Air Flow …………………………………………………… -litre/sec. 210 133
Exhaust Gas Flow ………………………………………………-litre/sec. 440 285
Turbo Comp. Outlet Temperature………………………………-℃ TBD TBD
Exhaust Gas Temperature…………………..………………… -℃ 500 530
Heat Rejection to Ambient…………..………………………… -kW TBD TBD
Heat Rejection to Coolant……………..………………………… -kW 72 55
Heat Rejection to Fuel……………..……………………..…...…-kW 0.5 0.3
Engine Coolant Flow…………………………..…...…...……... -litre/sec. 2.6 2.0
External Cooling Circuit Resistance……………...……...……-kPa△ P 20.7 20.7
Steady State Smoke…………………………………………… -Bosch 1 1.5