Professional Documents
Culture Documents
Checklist On Intramuscular Injection
Checklist On Intramuscular Injection
06-02-2014-00
UNIVERSITY OF PERPETUAL HELP SYSTEM LAGUNA
UNIVERSITY OF PERPETUAL HELP-DR. JOSE G. TAMAYO MEDICAL UNIVERSITY
COLLEGE OF NURSING
Goal: Medication is safely injected intradermally causing a wheal to appear at the site of injection.
4 3 2 1 Comments
Assessment
1 Gather equipment. Check each medication order against the original order in the
medical record according to facility policy. Clarify any inconsistencies. Check the
patient’s chart for allergies.
2 Know the actions, special nursing considerations, safe dose ranges, purpose of
administration, and adverse effects of the medications to be administered.
Considerhand
3 Perform the appropriateness
hygiene. of the medication for this patient.
4 Move the medication cart to the outside of the patient’s room or prepare for
administration in the medication area.
5 Unlock the medication cart or drawer. Enter pass code and scan employee
identification, if required.
Planning
6 Prepare medications for one patient at a time.
7 Read the CMAR/MAR and select the proper medication from the patient’s
medication drawer or unit stock.
8 Compare the label with the CMAR/MAR. Check expiration dates and perform
calculations, if necessary. Scan the bar code on the package, if required.
9 If necessary, withdraw medication from an ampule or vial (as described in Skills 5-
3 and 5-4.)
10 When all medications for one patient have been prepared, recheck the label with
the CMAR/MAR before taking the medications to the patient.
11 Lock the medication cart before leaving it.
12 Transport medications to the patient’s bedside carefully, and keep the
medications in sight at all times.
13 Ensure that the patient receives the medications at the correct time.
14 Perform hand hygiene and put on PPE, if indicated.
Implementation
Identify the patient. Usually, the patient should be identified using two methods.
Compare information with the CMAR/MAR.
15
a. Check the name and identification number on the patient’s
identification band.
b. Ask the patient to state his or her name and birth date,
16
based on facility policy
c. If the patient cannot identify him- or herself, verify the patient’s
17 identification with a staff member who knows the patient for
the second source.
18 Close the door to the room or pull the bedside curtain.
19 Complete necessary assessments before administering medications. Check
allergy bracelet or ask the patient about allergies. Explain the purpose and action
of the medication to the patient.
20 Scan the patient’s bar code on the identification band, if required.
21 Put on clean gloves.
Assist the patient to the appropriate position for the site chosen. Drape as needed
22 to expose only area of site to be used.
25 Remove the needle cap with the nondominant hand by pulling it straight off.
Administering Intramuscular Injection (page2)
Grasp and bunch the area surrounding the injection site or spread the skin taut at
26
the site.
27 Displace the skin in a Z-track manner by pulling the skin down or to one side
about 1 inch (2.5 cm) with your nondominant hand and hold the skin and tissue in
this position.
Quickly dart the needle into the tissue so that the needle is perpendicular to the
28 patient’s body. This should ensure that it is given using an angle of injection
between 72 and 90 degrees.
29 . As soon as the needle is in place, use the thumb and forefinger of your
nondominant hand to hold the lower end of the syringe. Slide your dominant hand
to the end of the plunger. Inject the solution slowly (10 sec/mL of medication).
Once the medication has been instilled, wait 10 seconds before withdrawing the
30 needle.
31 Withdraw the needle smoothly and steadily at the same angle at which it was
inserted, supporting tissue around the injection site with your nondominant hand.
32 Apply gentle pressure at the site with a dry gauze. Do not massage the site.
33 Do not recap the used needle. Engage the safety shield or needle guard. Discard
the needle and syringe in the appropriate receptacle.
34 Assist the patient to a position of comfort.
35 Remove gloves and additional PPE, if used. Perform hand hygiene.
36 Document the administration of the medication immediately after administration.
37 Evaluate the patient’s response to medication within appropriate time frame.
TOTAL = 148