Silica Fume
Silica Fume
www.AdvancedCementTechnologies.com
435 Martin Street, Suite 2040 - Blaine, WA 98230
Tel (800) 595 - 7552 • Fax (360) 332-9321
*The melting point temperature is dependent on the type of amorphous silica as well as the source.
Silica Fume is non-combustible even when in a dust cloud and presents no danger of explosion.
Flash Point: N/A Method Used: N/A
Extinguishing Media: N/A Explosion Potential: None
Special Fire Fighting Procedures: None Flammable Limits: None
Silica Fume is generally considered a nuisance dust of low toxicity. Use and handling of Silica Fume does
not represent a health risk when normal safety rules are observed. Silica Fume when handled and stored in
accordance with this document is unlikely to cause harmful effects. It is possible for Silica Fume to
contain trace amounts (<0.05%) of crystalline silica, which has been shown to cause silicosis, and has
been identified by IARC and NTP as a possible human carcinogen.
Inhalation: If inhaled to excess remove exposed person to a ventilated area or fresh air.
Skin Contact: Wash skin with water and mild soap.
Ingestion: Obtain first aid or medical assistance immediately.
Eye Contact: Flush eyes with water and carefully rinse under the eyelids. Obtain medical
assistance, if needed.
Normal Storage: General storage, best in closed containers, ambient air temperature, keep
dry.
Handling Precautions: Avoid generating dust. Handle with adequate ventilation for dust.
See OSHA 29 CFR 1910-94 (Ventilation)
Engineering Control: Provide sufficient mechanical (general and/or local exhaust) ventilation to
maintain exposures below PELs or TLVs in processing areas.
Respiratory Protection: Use 42 CFR 84 NIOSH/MSHA approved respirators when airborne
concentrations equal or exceed the Permissible Exposure Limit.
Skin Protection: Gloves are recommended.
Eye Protection: Use safety glasses with side shields. If the potential for exposure to particles
(airborne dust) which could cause mechanical injury to the eye wear safety
goggles.
Inhalation: Airborne Silica Fume dust generated by the use or handling of this product may
result in respiratory irritation.
Ingestion: Silica Fume dust may irritate and dehydrate throat and mouth.
Eye Contact: Silica Fume dust may cause eye irritation and dryness.
Skin Contact: Silica Fume dust may cause exposed skin irritation and dryness.
B. Chronic Effects:
Silica Fume is generally considered a nuisance dust of low toxicity consequently it is considered to pose
minimal risk of pulmonary fibrosis (silicosis). Avoid prolonged exposure to silica fume dust
concentrations above the recommended exposure limits, unless the protective equipment is used.
It is possible for Silica Fume to contain trace amounts (<0.05%) of crystalline silica, which has been
shown to cause silicosis, and has been identified by IARC and NTP as a possible human carcinogen.
Heating Silica Fume at temperatures above 500ºC (930ºF) for prolonged time periods will convert
amorphous silica to the crystalline phases Cristobalite and Tridymite that may cause silicosis. Increased
temperatures will increase the formation rate of these phases.
No adverse effects are expected. Silica Fume is not considered dangerous to the environment.
If Spilled: Collect using methods that minimize creation of airborne dust. High efficiency
vacuum cleaning is recommended to recover spilled material. Place in suitable
container for recycling or disposal.
Personal Safety: Observe health and safety precautions. Refer to Section IX.
Waste Disposal: Dispose of in accordance with applicable Federal, State and Local regulations.
This product has been reviewed according to the EPA “Hazard Categories” promulgated under
Sections 311 and 312 of the Superfund Amendments and Reauthorization Act of 1986 (SARA
Title III) and is considered, under applicable definitions, to meet the following categories:
Not Applicable
SARA 313:
This product contains the following substance subject to the reporting requirements of Section 313 of
Title III of the Superfund Amendments and Reauthorization Act of 1986 and CFR Part 372:
This product contains no chemicals subject to the SARA 313 supplier notification requirements.
CERCLA:
CERCLA section 103a specifically requires the person in charge of a vessel or facility to report
immediately to the National Response Center (NRC) a release of hazardous substance whose amount
equals or exceeds the assigned RQ.
It is possible for Silica Fume to contain trace amounts < 0.05% of crystalline silica.
HEALTH = 1
FLAMMABLILITY = 0
REACTIVITY = 0
PERSONAL PROTECTION = E – (see section IX)
All information, recommendations, and suggestions in this MSDS, concerning our products are based on
tests and data believed to be reliable, it cannot be guaranteed. Since the actual use by others is beyond
our control it is the user’s responsibility to determine the safety, toxicity and suitability for their own use
of the product described herein.