This document discusses biogas plants, including the types, construction, working, raw materials used, and advantages. There are two main types of biogas plants: fixed-dome and floating gas holder. The fixed-dome plant has a brick structure with five sections - mixing tank, inlet tank, digester, outlet tank, and overflow tank. The floating gas holder plant has a mixing tank, underground digester divided into two chambers, an inverted steel drum gas holder, and overflow tank. Both plants generate biogas through the anaerobic fermentation of biomass like animal dung and plant wastes in the digester. The biogas is then collected and used as a clean, efficient fuel.
This document discusses biogas plants, including the types, construction, working, raw materials used, and advantages. There are two main types of biogas plants: fixed-dome and floating gas holder. The fixed-dome plant has a brick structure with five sections - mixing tank, inlet tank, digester, outlet tank, and overflow tank. The floating gas holder plant has a mixing tank, underground digester divided into two chambers, an inverted steel drum gas holder, and overflow tank. Both plants generate biogas through the anaerobic fermentation of biomass like animal dung and plant wastes in the digester. The biogas is then collected and used as a clean, efficient fuel.
This document discusses biogas plants, including the types, construction, working, raw materials used, and advantages. There are two main types of biogas plants: fixed-dome and floating gas holder. The fixed-dome plant has a brick structure with five sections - mixing tank, inlet tank, digester, outlet tank, and overflow tank. The floating gas holder plant has a mixing tank, underground digester divided into two chambers, an inverted steel drum gas holder, and overflow tank. Both plants generate biogas through the anaerobic fermentation of biomass like animal dung and plant wastes in the digester. The biogas is then collected and used as a clean, efficient fuel.
Theory: Bio gas generated through a process of anaerobic digestion of Bio Mass. Bio Mass is organic matter produced by plants, both terrestrial (those grown on land) and aquatic (those grown in water) and their derivatives. Biogas is a clean and efficient fuel. The chief constituent of biogas is methane (65%). It is a mixture of following gases. SELECTION OF SITE FOR INSTALLATION OF A BIO GAS PLANT Following points to be considered while selecting a biogas plant 1. Distance between the plant and site of gas consumption or kitchen should be less to minimize cost on gas pipe line and gas leakage. 2. It should be near the cattle-shed to minimize the distance for carrying cattle dung and transportation cost. 3. There should be enough space for storage of digested slurry or construction of compost pit. 4. It should be 10 to 15 meters away from any drinking water well to prevent contamination of water. 5. The area should be free from roots of trees which are likely to creep into the digester and cause damage. 6. It should be open to receive the Sun‘s rays for most part of the day and to keep the plant in warm. The sunlight should fall on the plant as temperature between 15oC to 30oC is essential for gas generation at good rate. 7. It should be on an elevated area so that the plant does not get submerged during normal rains. 8. Sufficient space must be available for day to day operation and maintenance. As a guide line 10 to 12 M2 area is needed per M3 of the gas. 9. Plenty of water must be available as the Cow dung slurry with a solid concentration of 7% to 9% is used. USES OF BIOGAS 1. Domestic fuel 2. For street lighting 3. Generation of electricity 4. If compressed, it can replace compressed natural gas for use in vehicles. ADVANTAGES OF BIOGAS AS A FUEL 1. High calorific value 2. Clean fuel 3. No residue produced 4. No smoke produced 5. Non polluting 6. Economical 7. Can be supplied through pipe lines 8. Burns readily - has a convenient ignition temperature PRODUCTION OF BIOGAS - THE BIOGAS PLANTS There are two types of biogas plants in usage for the production of biogas. These are: 1. The fixed- dome type of biogas plant 2. The floating gas holder type of biogas plant Principle: Biogas is produced as a result of anaerobic fermentation of biomass in the presence of water. 1. Fixed- Dome Type of Biogas Plant Construction The biogas plant is a brick and cement structure having the following five sections: 1. Mixing tank: Mixing tank present above the ground level. 2. Inlet tank: The mixing tank opens underground into a sloping inlet chamber. 3. Digester: The inlet chamber opens from below into the digester which is a huge tank with a dome like ceiling. The ceiling of the digester has an outlet with a valve for the supply of biogas. 4. Outlet tank: The digester opens from below into an outlet chamber. 5. Overflow tank: The outlet chamber opens from the top into a small over flow tank. Raw material required 1. Forms of biomass listed below may be used along with water. 2. Animal dung 3. Poultry wastes 4. Plant wastes (Husk, grass, weeds etc.) 5. Human excreta 6. Industrial wastes (Saw dust, wastes from food processing industries) 7. Domestic wastes (Vegetable peels, waste food materials) Working of fixed dome type biogas plant: The various forms of biomass are mixed with an equal quantity of water in the mixing tank. This forms the slurry. The slurry is fed into the digester through the inlet chamber. When the digester is partially filled with the slurry, the introduction of slurry is stopped and the plant is left unused for about two months. During these two months, anaerobic bacteria present in the slurry decompose or ferments the biomass in the presence of water. As a result of anaerobic fermentation, biogas is formed, which starts collecting in the dome of the digester. As more and more biogas starts collecting, the pressure exerted by the biogas forces the spent slurry into the outlet chamber. From the outlet chamber, the spent slurry overflows into the overflow tank. The spent slurry is manually removed from the overflow tank and used as manure for plants. The gas valve connected to a system of pipelines is opened when a supply of biogas is required. To obtain a continuous supply of biogas, a functioning plant can be fed continuously with the prepared slurry. Advantages of fixed dome type biogas 1. Requires only locally and easily available materials for construction. 2. Inexpensive. 3. Easy to construct. 2. Floating Gas Holder type of Biogas Plant Construction The floating gas holder type of biogas plant has the following chambers/ sections: 1. Mixing Tank - present above the ground level. 2. Digester tank - Deep underground well-like structure. It is divided into two chambers by a partition wall in between. It has two long cement pipes i) Inlet pipe opening into the inlet chamber for introduction of slurry. ii) Outlet pipe opening into the overflow tank for removal of spent slurry. 3. Gas holder - an inverted steel drum resting above the digester. The drum can move up and down i.e., float over the digester. The gas holder has an outlet at the top which could be connected to gas stoves. 4. over flow tank - Present above the ground level. Working: Slurry (mixture of equal quantities of biomass and water) is prepared in the mixing tank. The prepared slurry is fed into the inlet chamber of the digester through the inlet pipe. The plant is left unused for about two months and introduction of more slurry is stopped. During this period, anaerobic fermentation of biomass takes place in the presence of water and produces biogas in the digester. Biogas being lighter rises up and starts collecting in the gas holder. The gas holder now starts moving up. The gas holder cannot rise up beyond a certain level. As more and more gas starts collecting, more pressure begins to be exerted on the slurry. The spent slurry is now forced into the outlet chamber from the top of the inlet chamber. When the outlet chamber gets filled with the spent slurry, the excess is forced out through the outlet pipe into the overflow tank. This is later used as manure for plants. The gas valve of the gas outlet is opened to get a supply of biogas. Once the production of biogas begins, a continuous supply of gas can be ensured by regular removal of spent slurry and introduction of fresh slurry.
Fig.2 Floating dome type biogas plant
Disadvantages of floating drum biogas plant 1. Expensive 2. Steel drum may rust 3. Requires regular maintenance