Download as pdf or txt
Download as pdf or txt
You are on page 1of 8

MATERIAL SAFETY DATA SHEET

FOR CHEMICAL PRODUCTS

1. IDENTIFICATION

Product Name: POLYKLEAR EPOXY RESIN SW 2224-A


Common Name or Synonyms: EPOXY RESIN SW 2224-A
Recommended use of the chemical Finishes and art applications
and restrictions on use:
Distributor: SEA Olympus Marketing Inc.
SEA Olympus Marketing Inc. Bldg.,
A.C. Cortes Avenue, Mandaue City, Cebu
Philippines 6014

2. HAZARDS IDENTIFICATION

Skin Irrit. 2 H315 Causes skin irritation


Eye Irrit. 2 H319 Causes serious eye irritation
Hazardous
Skin Sens. 1 H317 May cause an allergic skin reaction
chemicals
Aquatic Chronic 2 H411 Toxic to aquatic life with long lasting effects
classification
Acute Tox. 4 H312 Harmful in contact with skin
Acute Tox. 4 H332 Harmful if inhaled
Hazard symbol:

Label
contents

Warnings: Warning

Hazard statements:
Causes skin irritation.
Causes serious eye irritation.
May cause an allergic skin reaction.
Toxic to aquatic life with long lasting effects.
Harmful if inhaled
Harmful in contact with skin

Precautionary statements:
Avoid breathing dust/fume/gas/mist/vapors/spray.
Wear protective gloves/protective clothing/eye protection/face
protection.
IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do.
Continue rinsing.
Immediately call a POISON CENTER/doctor.

Additional information:
Contains epoxy constituents. May produce an allergic reaction.

3. COMPOSITION / INFORMATION ON INGREDIENTS

Hazardous ingredients Percentage CAS No. Chemical properties


Bisphenol-A Epoxy Resin 90-100 (%) 25068-38-6 Stable chemical material
1,4-Butanediol diglycidyl ether 0-10 (%) 2425-79-8 Stable inorganic material

4. FIRST AID MEASURES

First aid treatments with different kinds of Inhalation :


exposure ways Move to fresh air.
Oxygen or artificial respiration if needed
Call a physician immediately
Skin contact :
Wash off with soap and plenty of water.
If skin irritation persists, call a physician.
Eye contact :
Rinse immediately with plenty of water for
at least 15 minutes.
Call a physician immediately.
Ingestion :
Immediately give plenty of water (if
possible charcoal slurry)
If a person vomits when lying on his back,
place him in the recovery position.
Oxygen or artificial respiration if needed.
Do not induce vomiting.
Major symptom and Harm effect N/A
Protection for first aider Wear protective gloves/clothing and
eye/face protection
Prompt for doctor Immediately give plenty of water (if
possible charcoal slurry).
5. FIRE-FIGHTING MEASURES

Suitable extinguishing mediaWater spray


Carbon dioxide (CO2)
Foam
Dry powder
The hazards might encounter High volume water jet
while extinguishing
Particular extinguishment Burning produces obnoxious and toxic fumes
procedure Carbon oxides
Special equipment for fire Wear self-contained breathing apparatus and protective
fighter suit

6. ACCIDENTAL RELEASE MEASURES

Personal precautions Keep away from sources of ignition – No smoking.


Avoid contact with skin, eyes and clothing.
Do not breathe vapors/dust.
Environmental precautions Prevent product from entering drains.
Do not contaminate surface water.
Avoid subsoil penetration.
Methods for cleaning up Soak up with inert absorbent material and dispose of as
Hazardous waste.

7. HANDLING AND STORAGE

Handling Irritating
Sensitizing
Avoid formation of aerosol.
Ensure adequate ventilation.
When using, do not eat, drink or smoke.
Handle and open container with care.
Storage Further information on storage conditions:
Keep away from food, drink and animal feeding stuffs.
Keep container tightly closed.
Store at room temperature in the original container.
Storage hazard class
Storage class 12, Liquids, not dangerous
8. EXPOSURE CONTROLS / PERSONAL PROTECTION

Hazardous Testing Type Standard Remarks


ingredient basis value
Control Time Weighted Average N/A
Parameters Short-Term Exposure
N/A N/A N/A N/A
Limit
Ceiling N/A
Hazardous Testing Biological monitoring Biological Sampling
Biological
Ingredient basis index limit values Time
Exposure
N/A N/A
Indices N/A N/A N/A
N/A N/A
Engineering
N/A
Controls
Personal Respiratory protection:
protective Hand protection:
equipments Material of gloves for long term application
Butyl rubber
Ethyl Vinyl Alcohol Laminate (EVAL)
Material of gloves for short term/splash application
(10min<BTT<480 min)
Nitrile rubber
Neoprene rubber
Use gloves approved to relevant standards e.g. EN 734 (Europe),
F739 (US)
Suitability and durability of a glove is dependent on usage, e.g.,
frequency and duration of contact, chemical resistance of glove
material and dexterity. Always seek advice from glove suppliers.
Eye protection:
Tightly fitting safety goggles
Face-shield
Skin and Body protection:
Protective suit
Safety shoes
Health
N/A
measures

9. PHYSICAL AND CHEMICAL PROPERTIES

Partition coefficient:
Appearance Liquid NA
n-octanol/water
pH NA Critical temperature NA
Boiling Point NA Critical pressure NA
Melting point NA Auto-ignition temperature NA
Flash point >150℃ Decomposition temperature NA
Explosion limit NA Combustion heat NA
Odor NA Volatile rate NA
Vapor pressure NA Inflammability NA
Density 1.10 g/cm3 (25°C) Viscosity NA
Vapor density NA Odor threshold value NA
Solubility NA

10. STABILITY AND REACTIVITY

Stability Keep away from heat and sources of ignition. Do not


smoke.
The hazards might encounter
NA
in particular situations
Conditions to avoid Strong acids, strong oxidizing agents
Incompatible materials NA
Hazardous
Ammonia
decomposition products

11. TOXICOLOGICAL INFORMATION

Acute toxicity LD50: 1050 mg/kg


LC50: N/A
Exposure route N/A
Symptoms Skin irritation or corrosion Irritating
Eye irritation or corrosion Irritating
Breath or skin allergies N/A
Germ cell mutagenicity N/A
Carcinogenicity N/A
Genotoxicity N/A
Specific target organ toxicity after single N/A
exposure
Specific target organ N/A
Toxicity after multiple exposure N/A
Inhalation danger N/A
Long-term toxicity N/A
12. ECOLOGICAL INFORMATION

Eco-toxicity N/A
Persistence and degradability On the skin : irritating to skin
On the eye : irritating to eyes
Sensitization: sensitization possible by skin contact
Bioconcentration Prevent product from entering drains
Mobility in the soil Do not contaminate surface water
Other harmful influence N/A

13. DISPOSAL CONSIDERATIONS

Disposal considerations Be brought to a suitable disposal plant and burned


Chemical Waste In compliance with actual waste regulations, the product
or contaminant must be brought to a suitable disposal
plant and burned. No waste key number as per the
European Waste Types List can be assigned to this
product, since such classification is based on the (as yet
undetermined) use to which the product is put by the
consumer. The waste key number must be determined as
per the European Waste Types List (decision on EU
Waste Types List 2000/532/EC) in cooperation with the
disposal firm / producing firm / official authority.
Contaminated packaging Be brought to a suitable disposal plant and burned.
Disposal precautions N/A
14. TRANSPORT INFORMATION

U.N. No. UN3082


UN proper shipping name N/A
Transport hazard class 9
Packaging group III
Packaging mark

Packaging method N/A


Marine pollutants (Y/N) Y
Particular transportation N/A
and precautions

15. REGULATORY INFORMATION

Suitable regulatory Labeling according to EEC Directive


Labeling required
Warnings: Warning
Hazard statements:
H312: Harmful in contact with skin
H315: Causes skin irritation
H317: May cause an allergic skin reaction
H319: Causes serious eye irritation
H332: Harmful if inhaled
H411: Toxic to aquatic life with long lasting effects
National legislation
Water contaminating class:
3 highly water endangering (self-assessment)
Notification status:
EINECS: Yes
TSCA: Yes
AICS: Yes
DSL: Yes
INV (CN): Yes
JEX (JP): Yes
KECI (KR): Yes
PICCS (PH): Yes
16. OTHER INFORMATION

Updated on: 04-22-2021

Disclaimer: This SDS information is only available for appropriate products, unless
otherwise indicated, this product with other substances mixture cannot applicable. This
SDS is provided safety information for the staff who has had professional training. The
users of SDS must make an independent judgment on the suitability under special
conditions. If the SDS application results in injuries under a special occasion, the SDS
compilers do not bear any responsibility.

References:

1.CHEMINFO database, CCINFO disc, 2005-3


2.HSDB database, TOMES PLUS disc, VoL65,2005
3.RTECS database, TOMES PLUS disc, VoL65,2005
4.Hazardous chemicals database, EPA
5.ChemWATCH database, 2005-1

You might also like