FIC DCS Control Provided Santa Barbara Project - #219011

By Others NOTES:
Standard P&ID for Column with
1) All instruments and valves marked with an asterisk ( ) are supplied by EFD. All other instruments, valves
FI T
FIC
FY SlamJet Spargers *
and fittings, as well as all interconnect piping, wiring, trays and supports are by others.
LIT
* FE FC V
2) Pipe sizes shown are recommended only. Final size is by others.

LE
* 3) Vortex flow meters must be installed in a straight run of piping of same diameter as the flow meter bore, and
unobstructed by fittings or valves for 20 pipe diameters upstream and 5 pipe diameters downstream,
Water
DN100
M * * * DN100 measured from the instrument flange.

Max Supply Required DN80 DN100 DN65 DN100 4) Magnetic flow meters must be installed in a straight run of piping of same diameter as the flow meter bore,
65 m3/h Magnetic Flow Control Valve and unobstructed by fittings or valves for 5 pipe diameters upstream and 3 pipe diameters downstream,
Wash Water Ball Float
at 350 kPag Flow Meter
* Distributor & Target
measured from the instrument flange. Piping shall be arranged so that magnetic flow meters are always full.

DN80 Manual Flow Valve 5) In order to minimize pinch valve sleeve wear and to allow the valve to operate in an acceptable opening
Water * Launder spray ring range, the differential pressure across the valve should be limited to approximately 40 kPa (5.8 psi) by the
DN50 Internal (8 nozzles combined effect of static head and the barometric leg plus line friction losses. The level control pinch valve
Max Supply Required Launders with ball valves) has been sized based upon design flow and the above restrictions.
13 m3/h at 200 kPag
6) All flow meters and flow control valves are flanged.
Internal Feed
Distributor 7) Repulp valves must be installed as close as possible to the column shell.

8) Maximum air flow is calculated on a free air delivery basis. The reference for Nm 3/h is 0 °C and 101.325 kPa.
DN200 9) Design Flow = Nominal (Operating) Flow x 1.2
DN500
Feed
Design Flow
155 m3/h

Conc
Design Flow
xxx m3/h

Column
Flotation
FIC DCS Control Provided Cell
By Others
3 m Dia
Pressure regulating valve
highly recommen ded -
FIC
10 m H
Supplied by others FI T FY
Vent

* * FE
* Air Manifold PIT *
PRV
PI FC V
* DN15

Air * DN15
F
* * * * *
DNxx DN40 DN40 DN15
Max Supply Required DN25 DN40 DN25 DN40 DN40
610 m3/h Free Air Delivery Vortex Flow Control
Supply Pressure is 700 kPag Flow Meter Valve
DN25
*
*
DN25 Drain

* LIC DCS Control Provided

By Others
Repulp valves to be installed
CPT SlamJet as close as possible to shell
Sparger Assembly
(16 Places)
LIC
DN40

* * DN40
LCV
* IA
S HS Tail
Design Flow
DN200
* DN100 * xxx m3/h
*
DN40 DN200 Repulp DN100
Isolation Valve Flow Control
Repulp DN80 Repulp
Valve
* * DN50 *
DN150 DN80 Flush Valve
Drain Valve Drain Valve DN40
DN40

Column Line
Intermittent Drain Drain
Flow Only
Water

May 2019 – P00

Eriez Flotation Division – Canada Inc.