Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 2

Design and fabrication of Nano bio plant

Abstract

Methods such as landfilling, incineration, and aerobic composting of waste are not suitable
methods for their management because the production of greenhouse gases and the accumulation
of vermin and high cost and the need for a lot of space are the problems of using these methods.
The purpose of this study is to select a suitable method with the lowest energy consumption and
maximum efficiency in the use of waste. For this purpose, a dryer was designed and fabricated
for vegetable and food waste. The most suitable method of waste drying, the method of moving
the mass using a helix, was selected. In this food waste dryer, to prevent energy loss, the tank of
the device was made of double walls, and ceramic insulation was used between the two walls,
and the perforated tank inside the device will cause uniform drying by spreading heat to all parts
of the waste. Hot air from the tank outlet was also used. The results of the calculators showed
that about 10 kJ of energy is needed to remove about 3 kg of moisture from the waste. This high
capacity will be able to be used in small and large restaurants and kitchens and for livestock
consumption.

COMPACT DESIGN - IDEAL FOR SMALL LABORATORIES, DEMO BIOGAS PLANT FOR MICRO LAB TESTING PURPOSE,
TREATMENT OF FOOD WASTE AND PRODUCE METHANE BIOGAS FOR COOKING, LAB TESTING - BUNSEN BURNER FLAIR

You might also like