E-14 Sound Reception System
E-14 Sound Reception System
船型
38,000 DWT CHEMICAL TANK
HULL TYPE
船号
HT-CT001
HULL NO.
船厂
Hantong shipbuilding Co. Ltd.
SHIP OWNER
船级社
LR
CLASS
厂家
MRC
MAKER
供应商
JIANGSU HIGHLANDINTEGRATION TECHNOLOGY CO., LTD.
SUPPLIER
江 苏 海 兰 船 舶 电 气 系 统 科 技 有 限 公 司
(MSR-9200A, SRS)
Sound Reception System
Revision History
01 : Issued for first design : MSR-9200A
02 :
03 :
This document contains proprietary information and may not be copied, reproduced, or utilized in anyway, in all or in part without written
permission from Marine Radio Co., Ltd.
Copyright © 2010 Marine Radio Co., Ltd. All rights reserved.
Contents
--- Introduction ---
1. General Features ................................................................................................................................... 4
1.1 Features of the System .................................................................................................................. 6
1.2 System Configurations ................................................................................................................... 6
1.3 Name of Model ............................................................................................................................... 6
1. General Description
1.1 Features
This sound reception system is acoustic electronic navigational aids to enable the officer on the watch to
hear outside sound signals at totally enclosed
bridge in order to perform the look-out function as
required in the International Regulations for
Preventing Collisions at Sea, 1972. and SOLAS
2002(resolution A. 694(17)) revisions.
Thus, this system receives the sound signals in
all directions in the audio frequency 70Hz ~ 820Hz
and re-produces these incoming signals
electrically inside wheel house.
The four microphones operate in pair
depending of the approximate direction of the
received sound signal by these combinations.
The value for detection of sound signal is
75dBA.
The microphone active value of sound level for
detecting direction is more than 0.07mV between
forward and after or port and starboard.
-1. Terminal Block: AC/DC Input and DC Output -2. AC Input Fuse: 1A (2AG)
-3. DC Input Fuse: 2A (2AG) -4. DC Output Lamp: LED(Red) Type
-5. AC Input Switch -6. DC Input Switch
-7. Ventilation Holes
3. Precautions on Installation
3.1 Setup of Microphone's Input Sensitivity
-1. The potentiometer(VR1~VR4)
adjusts the sound signal on
direction lamp.
The squelch circuit input
value(Maker standard) is set on
75dBA.
If needed, it may adjust again so
as to be proper at environment
conditions.
-2. The performance of this system depends upon the installation position of the microphone.
-3. Install the microphone in each side of the bridge wing/bow/stern or bridge top.
The microphones must be separated about 10-meter.
-4. Install the microphone in the place to avoid the wind generated by the ship.
-5. To prevent the howling, do not install a microphone in the entrance, window, and console speaker
or opening and closing door in the wheelhouse.
-6. The microphone U-bracket is fastened securely in place.
-7. When you install the microphone cable, wind the extra cable on the end of cable once more and
fasten it.
-8. To prevent the interference, do not combine the signal cables with other cable type such as power
source. The sound reception system should be connected with the other ones separately.
-9. To do so, protect the microphone from the vibration of the ship.
-10. Also, protect it from the vibration generated by the high sensitivity elements of the microphone.
-11. For sound reliability, the microphone should be installed at silent place
-12. When the howling occurs, turn down the volume until the howling stops.
Please, consult the manufacturer if the above problems are not improved after troubleshooting.