Professional Documents
Culture Documents
Etce 208
Etce 208
1.
L T C 3 1 4
Maximum Marks : 75
Question No.1 should be compulsory and cover the entire syllabus. This question should have objective or short answer type questions. It should be of 25 marks. Apart from question No.1, rest of the paper shall consist of four units as per the syllabus. Every unit should have two questions. However, student may be asked to attempt only one question from each unit. Use of relevant Indian Codes/Standards/Guidelines will be permitted
UNIT I
Properties of hardened concrete: Effects of water cement ratio, compaction, age, curing on strength of concrete. Compressive strength, grades of concrete, tensile strength, bond strength, stress strain characteristics, modulus of elasticity, Poissons ratio, shrinkage and creep, durability, requirement for material used in concrete as per I.S. code, permeability, chemical attack, Sulphate attack, resistance to abrasion, cavitations, freezing and thawing, resistance to fire, marine atmosphere. Basic design principles: Reinforced concrete design philosophies: Working stress design, Concept of limit states. Limit states design, partial safety factors and Codal recommendations. Characteristic and design values, factored loads, design stress strain curves. Limit state of collapse: Flexure, shear, bond and torsion. Structural Masonry: Behaviour of Load Bearing Masonry Wall, Introduction of Reinforced Masonry, analysis of lintel beams. [No. of Hours: 10] UNIT II Limit state of collapse: Compression: Braced and unbraced columns, behavior of reinforced concrete columns, general design principles: Longitudinal and transverse reinforcement, Effective length of columns in building frames. Limit state of Serviceability: Short term and long term deflection estimates and codal provisions, crack formation in columns and beams and its control, crack width. Limit state for lateral stability, serviceability, fire resistance, fatigue, durability in services life of structure. Analysis and design of singly and doubly reinforced simply supported cantilever and continuous beams, T and L shaped beams, lintels, design of beam for torsion, [No. of Hours: 10] UNIT III Design of simply supported, cantilever slabs, one way and two way slabs, continuous slabs both one way and two way, Design of staircases, Design of short columns under axial load. [No. of Hours: 12] UNIT IV Design of short and slender columns under axial load, under uniaxial and biaxial bending and shear force. Design of isolated footing for vertical load and Moment, Design of combined footings. [No. of Hours: 10] Suggested Reading: 1. Design of Reinforced Concrete Structures, M.L.Gambhir, Prentice Hall of India Publications. 2. Concrete Technology, Neville, Pearson Education. 3. Concrete technology, M.S. Shetty, S. Chand & Co. 4. Limit State Design of Reinforced Concrete structures, A.K. Jain, Nem Chand Publishers, Roorkee 5. Concrete Technology, M. L. Gambhir, McGraw Hill Publications 6. Properties of Concrete, Neville, Pearson Education 7. Reinforced Concrete Design Principles and Practice, Krishna Raju, N.Pranesh, R.N., New International Publications. 8. Reinforced Concrete Design, S.N. Sinha, The Mc Graw Hill Publications. 9. Limit State Design of Reinforced Concrete, Varghese, P.C., PHI Publications. 10. Concrete Technology, A.R. SanthaKumar, Oxford Publications. 11. Reinforced Concrete Design, S.N. Sinha, Tata Mc Graw Hill Publications. 12. Reinforced Concrete Design, S. Unnikrishna, Pillai, ,Tata Mc Graw Hill Publications