Professional Documents
Culture Documents
Road Line Paint - Spec - en
Road Line Paint - Spec - en
10
: : : :
White, Yellow, Red and Black Matt 1.37 0.05 (1) 42 2 by volume (1)
Performance Characteristics: Excellent eye visibility Hard and abrasive resistant Very fast-drying Weather-resistant
Recommendation for Use: Surface Preparation The surface must be clean, dry, free from grease, oil and any others foreign matter. Recommended No. of Coats Recommended Film Thickness per coat Theoretical Coverage at Recommended Film Thickeness : : : 2 coats 35 microns for dry film 84 microns for wet film 12.0 m2 / liter (for dry film thickness of 35 microns) Theoretical Coverage = Volume Solid (%) x 10 Dry Film Thickness () (m2/ liter) Practical Coverage (20% Loss Factor) : 9.6 m2 / liter (for dry film thickness of 35 microns)
Page 1
Application Data: Application Methods Guiding Data for Spray : : Delivery Pressure (kg/cm2) Tip size at 60 angle Thinning : Roller & Brush Air Spray Airless Spray
o
Brush, roller, compressed air spray and airless spray Air 3-4 1.3 mm 10% maximum 20% maximum 5% maximum Airless 140 - 170 0.015" - 0.017"
: :
Note: All equipment should be cleaned IMMEDIATELY with Thinner after use. For thinning, substitute thinners other than those approved or supplied by Nippon Paint may adversely affect the product performance and void product warranty whether expressed or implied.
Drying Time at 25oC to 30oC: Dry to touch Dry to handle Dry to overcoat : : : Approximately 5 minutes 1 hour Minimum 1 hour
Standard Packing
5 Liters
Environmental Conditions during Application: 1. 2. 3. Do not apply when the relative humidity exceeds 85%. The temperature of the substrate to be painted must be 3C higher than the dew point. Do not apply at temperature below 7C. If not, drying and overcoating time will be considerably extended. During application of the paint, naked flame, welding operations and smoking should not be allowed and good ventilation is necessary.
Safety, Health and Environmental Information: 1. 2. Flammable Liquid. Do not expose to heat, sparks or open flame. Skin Contact: May cause moderate skin irritation. Avoid prolong contact with skin. Use solvent resistant glove. To remove splashes of paint from skin, use soap and water.
Page 2
NOTE: The information given applies to the product and its performance under specific test conditions. Due to the varied circumstances beyond our control under which the product may be applied, for specific application, please contact Nippon Paint Sales & Marketing Dept. We reserve the right to modify our product data sheet without further notice.
Page 3