| 1. Remove the nuts securing your
seat to your seat plate. Remove your current seat and any loose shims.
|
|
| Your seat plate may have one of
these shapes.
If you have questions or need a custom
adaptor, call customer service Toll Free (855) 855-1976
|
|
| 2. Line up the holes and slots. Bolt the adaptor plate (black
in the photo) to current bike seat plate using nuts, bolts and washers provided. Use adjustable wrench
to tighten nuts securely. |
|
| You may need to slide the top
bar up or down to match your holes. |
|
| Please note 3 hole plates and
some 4-hole plates do not use the cross bar.
Some large plates need an extension bar.
|
|
|
NOTE:
If your post clamp is not already on your seat, see seat
post clamp installation instructions.
You may need to rotate the clamp to the
forward position if the adaptor plate hits the rear springs of the
seat. |
 |
| 3. Slide black post clamp and seat
- onto the post of the adaptor plate.
|
 |
| Rotate seat from side to side, front to back, and
up and down, to position seat in proper position according to enclosed
instructions. Seat should tilt very slightly down to the front. |
 |
|
Tighten black nuts on both sides of black adaptor
until tight and seat does not move.
|
 |
|
You may need to lower your large seat post 3 to
5 inches to accommodate the adaptors and new seat.
Check nuts after 1 week and tighten as necessary.
If you need assistance, call customer service
Toll Free (855) 855-1976
|
