FortiOS v6.4.10 has been
released:https://docs.fortinet.com/document/fortigate/6.4.10/fortios-release-notes/760203/introduction-and-supported-models
hi, today I set up email alerts for various events (so, event based and
not severity level based), and I am missing a setting for hardware
failure events, you know, fans, PSU, temperature. A look into the CLI
didn't help.Am I thinking too hard, and t...
Hello fellows, for simplicity, I often use my private SSH key to log in
into my local admin account on various FGTs (I mean, CLI access via
SSH). Now, if instead of a local admin account I use a wildcard admin
account against LDAP/MS AD in the backgr...
hello all, I've got a pair of FG-200B running v4.3.18 in A-P HA mode.
Each cluster member is at a different location, HA links are across a
dedicated line. On each site, there is one Cisco access router (19xx) in
front of the FGT providing WAN access...
hello all, I'm planning to place the slave unit of a Fortigate HA
cluster into a remote location. There is a leased line (layer 2) for the
HA connect. Can anybody confirm that I can run the HA traffic across a
VLAN between the access switches on each...
I feel it should be mentioned that while disabling the "exec" command in
the admin profile will solve the problem, it will block a lot of
'innocent' commands as well. Like ping, ping-options, traceroute.
Whether an admin could live with that, or shou...
Hopefully, this article will help you in
debugging:https://community.fortinet.com/t5/FortiGate/Technical-Tip-Initial-troubleshooting-steps-for-LACP-Link/ta-p/198339
In fact, a default LAG port starts out with default settings suitable
for Cisco switc...
Better still, Fortinet has got a Trade Up program which offers a
substantial rebate over the listprice. Replacing a 100E with an 100F
will be covered, so I'd get a TradeUp offer from your FTNT dealer of
choice.There is even a suitable replacement in ...
What @amrit is really telling you is, you need a FGT as a switch
controller as this software is not embedded in 3rd party firewalls of
any other vendor, AND yes, the way you have depicted a FortiLink
connection to your switches from your FGT (be it l...
OK, in order to forward traffic, the FGT needs to have a route AND needs
to have a policy allowing it.You do not mention that this traffic is
forwarded by a policy route. A policy route (PR) alone will not forward
traffic. It sends packets to interfa...