Jump to content

Rollin film

From Wikipedia, the free encyclopedia
Helium II will "creep" along surfaces in order to find its own level – after a short while, the levels in the two containers will equalize. The Rollin film also covers the interior of the larger container; if it were not sealed, the helium II would creep out and escape.
The liquid helium is in the superfluid phase. As long as it remains superfluid, it creeps up the inside wall of the cup as a thin film. It comes down on the outside, forming a drop which will fall into the liquid below. Another drop will form – and so on – until the cup is empty.

A Rollin film, named after Bernard V. Rollin, is a 30 nm-thick liquid film of helium in the helium II state. It exhibits a "creeping" effect in response to surfaces extending past the film's level (wave propagation). Helium II can escape from any non-closed container via creeping toward and eventually evaporating from capillaries of 10 to 100 nm or greater.

Rollin films are involved in the fountain effect where superfluid helium leaks out of a container in a fountain-like manner. They have high thermal conductivity.

The ability of superfluid liquids to cross obstacles that lie at a higher level is often referred to as the Onnes effect, named after Heike Kamerlingh Onnes. The Onnes effect is enabled by the capillary forces dominating gravity and viscous forces.

Waves propagating across a Rollin film are governed by the same equation as gravity waves in shallow water, but rather than gravity, the restoring force is the van der Waals force. The film suffers a change in chemical potential when the thickness varies. These waves are known as third sound.

Thickness of the film

[edit]

The thickness of the film can be calculated by the energy balance. Consider a small fluid volume element which is located at a height from the free surface. The potential energy due to the gravitational force acting on the fluid element is , where is the total density and is the gravitational acceleration. The quantum kinetic energy per particle is , where is the thickness of the film and is the mass of the particle. Therefore, the net kinetic energy is given by , where is the fraction of atoms which are Bose–Einstein condensate. Minimizing the total energy with respect to the thickness provides us the value of the thickness:[1]

See also

[edit]

References

[edit]
  1. ^ Huang, K. (2017). A superfluid universe. World Scientific.
  • Fairbank H.A.; Lane C.T. (October 1949). "Rollin Film Rates in Liquid Helium". Physical Review. 76 (8): 1209–1211. Bibcode:1949PhRv...76.1209F. doi:10.1103/PhysRev.76.1209.{{cite journal}}: CS1 maint: multiple names: authors list (link)
  • B.V. Rollin and F. Simon (1939). "On the "film" phenomenon of liquid helium II". Physica. 6 (2): 219–230. Bibcode:1939Phy.....6..219R. doi:10.1016/S0031-8914(39)80013-1.
  • David Goodstein (5 July 1969). "Third Sound and the Onset of Superfluidity in Unsaturated Helium Films" (PDF). Physical Review. 183 (1): 327–334. Bibcode:1969PhRv..183..327G. doi:10.1103/PhysRev.183.327.
[edit]